Cardiff University | Prifysgol Caerdydd ORCA
Online Research @ Cardiff 
WelshClear Cookie - decide language by browser settings

A polymer of intrinsic microporosity as the active binder to enhance adsorption/separation properties of composite hollow fibres

Jeffs, Corinne A., Smith, Martin W., Stone, Corinne A., Bezzu, Caterina Grazia, Msayib, Kadhum J., McKeown, Neil B. and Perera, Semali P. 2013. A polymer of intrinsic microporosity as the active binder to enhance adsorption/separation properties of composite hollow fibres. Microporous and Mesoporous Materials 170 , pp. 105-112. 10.1016/j.micromeso.2012.11.039

Full text not available from this repository.

Abstract

Sorbent hollow fibres, generally prepared by fully encapsulating an adsorbent within a polymer binder such as polyethersulfone (PES), provide a low pressure drop alternative to conventional packed beds. These fibres have a high external surface area to volume ratio, enabling smaller bed sizes, and a highly porous structure resulting in low mass transfer resistance while maximising sorption efficiency. However, adsorbent hollow fibres prepared with PES suffer from loss of some adsorption capacity due to the polymer binder. This paper describes a novel formulation of composite hollow fibres containing activated carbon and PIM-1, a polymer of intrinsic microporosity, as an active binder designed to enhance the total adsorption capacity. Octane has been selected as a model hydrocarbon, and nitrogen and octane isotherms are reported for both PES and PIM-1 based hollow fibres, each containing the same activated carbon. Theoretical BET surface areas were calculated for each type of fibre based on a weighted average of the surface areas of its individual components (i.e. polymer and carbon). The measured surface area of the PIM-1 fibres was remarkably consistent with the theoretical value, while the measured surface area and octane uptake for PES fibres were ∼10% lower than the theoretical values, indicating some blockage of the adsorbent by the polymer matrix. PIM-1 adsorbent fibres were found to fully utilise the capacity of the supported carbon, as well as providing additional sites for adsorption on the polymer, resulting in a maximum octane uptake of 50% w/w – approximately twice that of the PES-based fibres.

Item Type: Article
Date Type: Publication
Status: Published
Schools: Chemistry
Publisher: Elsevier
ISSN: 1387-1811
Date of Acceptance: 29 November 2012
Last Modified: 04 Jun 2019 10:54
URI: https://orca.cardiff.ac.uk/id/eprint/123150

Citation Data

Cited 11 times in Scopus. View in Scopus. Powered By Scopus® Data

Actions (repository staff only)

Edit Item Edit Item