Bulk TiCxN1-x-15%Co cermets obtained by direct spark plasma sintering of mechanochemical synthesized powders

Borrell, Amparo, Salvador, María Dolores, Garcia Rocha, Victoria ORCID: https://orcid.org/0000-0001-6125-8556, Fernández, Adolfo, Avilés, Miguel Ángel and Gotor, Francisco J. 2012. Bulk TiCxN1-x-15%Co cermets obtained by direct spark plasma sintering of mechanochemical synthesized powders. Materials Research Bulletin 47 (12) , pp. 4487-4490. 10.1016/j.materresbull.2012.09.066

Full text not available from this repository.

Abstract

TiCxN1−x–15 wt.%Co cermets were obtained by a mechanically induced self-sustaining reaction (MSR) and sintered by spark plasma sintering (SPS) technique at different temperatures (1200–1400 °C) for 1 min in vacuum under a uniaxial load of 80 MPa. The evolution of microstructure and mechanical properties was investigated. SPS allowed high densification with limited grain growth at a relatively low temperature. Material sintered at 1300 °C showed a good combination of mechanical properties with Vickers hardness of 17.1 ± 0.5 GPa, fracture toughness of 5.51 ± 0.29 MPa m1/2 and bending strength of 904 ± 12 MPa. Lower sintering temperature resulted in a decrease in bending strength due to poor cohesion between the ceramic and binder phases. An increase in sintering temperature would allow tailoring the cermet microstructure and, therefore, adjusting the Vickers hardness/fracture toughness relation.

Item Type:	Article
Date Type:	Publication
Status:	Published
Schools:	Engineering
Subjects:	T Technology > TA Engineering (General). Civil engineering (General)
Publisher:	Elsevier
ISSN:	0025-5408
Date of Acceptance:	29 September 2012
Last Modified:	01 Nov 2022 10:57
URI:	https://orca.cardiff.ac.uk/id/eprint/93344

Citation Data

Cited 12 times in Scopus. View in Scopus. Powered By Scopus® Data

Actions (repository staff only)

Edit Item